The process of carving a silver dragon pendant can be very complex and require specialized equipment. The size is not money, but a special wax. Then, the wax in a form where they melt, usually generated by a steam engine. Then, to make money in the form of the spin. Thus the figure of the Silver Dragon for cleaning mold and finish.
To sculpt your dragon pendant, jewelry wax as wax needs equipment. Watch for details on the dragon, like teeth, tails, scales and wings. You can use a dragon design in the traditional style, including Chinese dragon with a lion or a dog so much and almost no wing or the design of modern fantasy can choose to take a look at the Serpentine. You can use a cool tool for a rougher surface for drivers and hottest tool to achieve a softer feel. Make sure all the details you need to get the kite into the wax finish.
Find out what section of the dragon, to use as an accessory to your necklace, and the wings or the bow. You have to drill a flat surface with enough space for the thumb of 1 / 16, so that about 1 / 16 in price range between the edge and the hole. Once a source of molten wax and then a bit sticky wax to the welfare of some of the dragon, put less detail, as the leg or chest.
Allow to cool and solidify their tendency Silver Dragon about two hours to get rid of the shine and then we can open it with a hammer. It is used to clean a little hot water and a toothbrush, put the remains of plaster, make sure to clean the extent of the surface structure and between the toes.
0 comments:
Post a Comment